Schneider XX930A3A2M12 M30 ultrasonic proximity sensor: application and replacement notes
The exact code XX930A3A2M12 should be retained on every service request for this M30 ultrasonic proximity sensor. The main image is a shared category reference; it does not establish the precise appearance, options or rating of the ordered XX930A3A2M12.
Technical data at a glance
| Technical item | Verified value / selection note |
|---|---|
| Full reference | XX930A3A2M12 |
| Product identity | M30 ultrasonic proximity sensor |
| Nominal range | Up to 8 m model listing |
| Housing | M30 cylindrical |
| Connection | M12 connector |
| Output | Confirm analog setting from exact data sheet |
Where the item is used
For XX930A3A2M12, first identify the machine, panel or signalling assembly and the duty performed by this M30 ultrasonic proximity sensor. Record nearby accessories and the installed orientation. Check target geometry and configured sensing window. The model code XX930A3A2M12 should be compared with the physical nameplate, not reconstructed from a photograph.
What changes the selection
A replacement for XX930A3A2M12 must fit the electrical supply, output or contact logic, mechanical interface and environmental conditions that apply at the site. Check the manufacturer document for XX930A3A2M12 and the actual assembly revision. If a proposed alternative differs, require engineering approval before ordering.
What to record after installation
Before removal, capture the original XX930A3A2M12 terminals, wiring, settings and mounting position. After installation of XX930A3A2M12, complete the applicable isolation, functional and commissioning checks. Store the delivered label, test result and any approved variation with the asset record.
Procurement interpretation
Quote XX930A3A2M12 in full, then request the latest technical sheet, quantity, accessory scope, destination and lead time. A distributor may show a generic image for XX930A3A2M12; the purchasing decision should use the complete written reference and the final application review.
If XX930A3A2M12 belongs to a legacy range, confirm lifecycle and recommended replacement in the intended country. Do not carry over settings, safety assumptions or connection pinouts from XX930A3A2M12 to a different part without checking both product documents.
Visually similar catalogue codes
No additional unassigned code with the XX930 visual pattern is grouped here. Any alternative to XX930A3A2M12 still needs its own technical check.
Order conclusion
Specify XX930A3A2M12 as printed, confirm the installed application and request supporting manufacturer documentation. For XX930A3A2M12, the final site engineer must approve any proposed deviation before the equipment is returned to service.
