Identify XUVE04M3KSNM8 before selecting a replacement
The exact code XUVE04M3KSNM8 should be retained on every service request for this XUV label-detection fork sensor. The main image is a shared category reference; it does not establish the precise appearance, options or rating of the ordered XUVE04M3KSNM8.
Technical data at a glance
| Technical item | Verified value / selection note |
|---|---|
| Full reference | XUVE04M3KSNM8 |
| Product identity | XUV label-detection fork sensor |
| Fork opening | 3 mm |
| Fork depth | 40 mm |
| Supply | 12 to 24 V DC |
| Connector | M8 |
| Output | Programmable PNP/NPN |
Where the item is used
For XUVE04M3KSNM8, first identify the machine, panel or signalling assembly and the duty performed by this XUV label-detection fork sensor. Record nearby accessories and the installed orientation. Check label gap, speed and output configuration. The model code XUVE04M3KSNM8 should be compared with the physical nameplate, not reconstructed from a photograph.
What changes the selection
A replacement for XUVE04M3KSNM8 must fit the electrical supply, output or contact logic, mechanical interface and environmental conditions that apply at the site. Check the manufacturer document for XUVE04M3KSNM8 and the actual assembly revision. If a proposed alternative differs, require engineering approval before ordering.
What to record after installation
Before removal, capture the original XUVE04M3KSNM8 terminals, wiring, settings and mounting position. After installation of XUVE04M3KSNM8, complete the applicable isolation, functional and commissioning checks. Store the delivered label, test result and any approved variation with the asset record.
Procurement interpretation
Quote XUVE04M3KSNM8 in full, then request the latest technical sheet, quantity, accessory scope, destination and lead time. A distributor may show a generic image for XUVE04M3KSNM8; the purchasing decision should use the complete written reference and the final application review.
If XUVE04M3KSNM8 belongs to a legacy range, confirm lifecycle and recommended replacement in the intended country. Do not carry over settings, safety assumptions or connection pinouts from XUVE04M3KSNM8 to a different part without checking both product documents.
Visually similar catalogue codes
No additional unassigned code with the XUVE visual pattern is grouped here. Any alternative to XUVE04M3KSNM8 still needs its own technical check.
Order conclusion
Specify XUVE04M3KSNM8 as printed, confirm the installed application and request supporting manufacturer documentation. For XUVE04M3KSNM8, the final site engineer must approve any proposed deviation before the equipment is returned to service.
