What to verify for GV2P01: Schneider TeSys Deca motor circuit breaker
GV2P01 is the complete Schneider Electric ordering designation for the TeSys Deca motor circuit breaker. The category main image is a shared reference collage, not an exact photograph of GV2P01. The points below separate manufacturer-supported specifications from site-specific choices.
Technical parameters
| Technical item | Verified value / selection note |
|---|---|
| Complete model | GV2P01 |
| Product identity | TeSys Deca motor circuit breaker |
| Adjustment | 0.1–0.16 A |
| Poles | 3 |
| Operation | Rotary handle, screw terminals |
What does GV2P01 identify?
The GV2P01 code identifies the product type and variant described in the table. Keep every character of GV2P01 in purchasing and maintenance records. A partial code or similar photograph cannot establish an exact replacement.
Which application checks matter for GV2P01?
Set the motor-current band from the nameplate and review short-circuit coordination.
Before releasing GV2P01, compare the installed supply, load, enclosure, terminals, network or mechanical interface as applicable. Match the actual GV2P01 nameplate and panel drawing to the current manufacturer data. Include any required accessory as a separate line item.
How should GV2P01 be installed and tested?
Qualified personnel should isolate the equipment under site procedure, record the original wiring and configuration, then fit GV2P01 according to the relevant instructions. Preserve any software backup or settings associated with GV2P01.
After installation, test the intended operating sequence and record measured values, indications, alarms and the delivered GV2P01 reference. For a protection or safety component, GV2P01 must be validated within the complete application; the part code alone does not prove compliance.
Related-looking codes grouped with this representative
These 99 unassigned codes share the visible GV2 pattern with GV2P01. They are included on this representative page and are not queued as separate product pages. Their technical specifications may differ from GV2P01; check the full code before substitution.
Final procurement note
Confirm the availability and regional lifecycle of GV2P01, the current datasheet revision and the delivered label. Keep the GV2P01 selection decision with the installation record so a later service team can reconstruct why this exact item was ordered.
