Danfoss 017B0002 BCP1 pressure switch for low-pressure monitoring and service selection
Danfoss 017B0002 identifies a BCP1 pressure switch. The technical data below follows the cited manufacturer record for this exact code. The shared main image is a category reference and not a photograph of the exact Danfoss 017B0002 item.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete order number | 017B0002 |
| Manufacturer / item class | Danfoss BCP1 pressure switch |
| Regulation range | 0.1–1.1 bar Pe |
| Differential | 0.15–0.6 bar |
| Reset / contact | Automatic reset / SPDT gold contact |
| Port / enclosure | G 1/2 male / IP65 |
| Image scope | Shared Danfoss category collage, not exact-item photograph |
| Final selection rule | Verify complete printed code, interface and application before substitution |
Setpoint and trip duty
For Danfoss 017B0002, record the existing operating setpoint and differential before replacing the switch; verify both are within the published BCP1 range.
Control interface
For Danfoss 017B0002, compare SPDT contact wiring, DIN connector and control-circuit rating with the installed drawing.
Proof test
For Danfoss 017B0002, verify the pressure at which the contact changes state, then confirm the connected controller responds safely.
Similar-looking Danfoss order references
These order strings resemble Danfoss 017B0002 visually and are listed for enquiry searches only. They can have different functions, ratings or connections. They are not automatic alternatives to Danfoss 017B0002; verify each complete code independently.
Ordering and receiving review
Request a quotation against the full Danfoss 017B0002 code and the installed equipment record. Check manufacturer status, pack quantity and all relevant electrical or process interfaces. An offer based only on a similar-looking model number requires a separate technical comparison.
When Danfoss 017B0002 arrives, inspect the label and supplied connections before installation. Record the installed setting, configuration or functional test result so future service enquiries retain the exact Danfoss 017B0002 identity.
