XCKD2118P16 technical identity and replacement considerations for Telemecanique XC limit switch

XCKD2118P16 is the complete ordering reference for a Schneider Electric Telemecanique XC limit switch. This page identifies the confirmed characteristics of XCKD2118P16 and the practical fit checks for an existing installation. The shared category collage is a reference image, not an exact photograph of XCKD2118P16.

Technical parameters and confirmed identity

What the code identifies

The XCKD2118P16 designation identifies the part above, not every accessory in the complete system. Purchase and maintenance records should retain the exact XCKD2118P16 characters, including any suffix. Where a similar-looking reference exists, compare its full specification rather than treating it as an automatic replacement.

For XCKD2118P16, the parameter table separates product identity from site-specific engineering decisions. Ratings in a family brochure may cover several variants; the installed XCKD2118P16 nameplate and current manufacturer data remain the final order check.

Application fit and engineering boundaries

Confirm cam travel, lever angle and contact timing on the actual machine.

Before accepting XCKD2118P16, compare the existing panel or machine drawing with the relevant voltage, current, contact, network, pressure or mechanical interface noted for this product. Record cable entry, mounting space, connected load and environmental conditions where applicable.

A procurement request for XCKD2118P16 should state the equipment tag and purpose, not just the part number. If the original unit has options or accessories, list them separately; a replacement XCKD2118P16 may not include those items.

Installation and functional record

Qualified personnel should isolate the equipment under the site's procedure before fitting XCKD2118P16. Photograph the original connections, label conductors, and retain any software or parameter backup relevant to XCKD2118P16.

After installation of XCKD2118P16, test the operating sequence in a safe state. Record measured supply or signal values, status indications, alarms and the final XCKD2118P16 reference on the handover sheet.

If XCKD2118P16 is a safety, protection or switching component, complete the application-specific coordination and validation process. The information here is not a substitute for the machine risk assessment or electrical design review.

Similar-looking codes covered by this page

The following codes resemble XCKD2118P16 and are grouped here as reference variants, so they are not scheduled as separate product pages. Similar spelling does not mean electrical or mechanical interchangeability. Compare each full code, option and rating to XCKD2118P16.

Order release checklist

For XCKD2118P16, confirm the full designation, the actual installed interface, the rating or setting in the table, and the availability of any required mating part. Mark any deviation from the original XCKD2118P16 installation for engineering review.

The final XCKD2118P16 selection should be checked against current Schneider Electric product documentation and the delivered device label. Preserve the commissioning record with the order so future XCKD2118P16 service decisions remain traceable.