Schneider PK7GTA load-center ground bar kit technical record
Use the full PK7GTA designation when discussing this load-center ground bar kit with a supplier or engineer. The Schneider category main image is a shared reference collage, not an exact photo of PK7GTA. The table records limited confirmed facts; the site-specific decision requires the current product document and installed-system information.
Verified technical reference
| Technical item | Verified value / selection note |
|---|---|
| Complete model | PK7GTA |
| Product identity | load-center ground bar kit |
| Component | Ground bar kit |
| Use | Load center used as subpanel |
| Manufacturer reference | PK7GTA |
Where the item fits
The selection question for PK7GTA is not simply whether the code looks familiar. Identify its actual role as load-center ground bar kit, the equipment it connects to, and the site operating conditions. Confirm load-center model and grounding scheme. Record any missing interface value as a question to verify rather than filling it from a neighboring model.
Keep PK7GTA in the equipment schedule with the intended host, panel or circuit. A shared product picture can show the general category, but it cannot verify terminal layout, voltage, current, firmware or mechanical dimensions of the delivered PK7GTA.
Mating and integration checks
Before ordering PK7GTA, compare electrical supply, protection, signals or communication settings where relevant. Confirm mechanical installation, mating connector and accessory dependencies. If an engineering drawing refers to another code, obtain an approved cross-reference before substituting PK7GTA.
For maintenance replacement, capture the original nameplate and any revision label. Compare the complete string with PK7GTA; a changed suffix can alter a component's function. Review thermal, environmental and safety limits with the manufacturer's exact documentation, not with a general family image.
Quotation and receiving controls
Ask for an offer naming PK7GTA exactly, with quantity, destination, lead time and current data sheet. Clarify whether a cable, fuse, mounting part, software or other accessory is included. If PK7GTA is discontinued, ask for a documented alternative and evaluate its differences before purchase.
When PK7GTA arrives, inspect package condition and label. Confirm that the full marking matches the approved order, photograph it and record the supplier's reference. Quarantine a unit labelled differently from PK7GTA until the substitution has been reviewed.
Installation and acceptance
Install PK7GTA under the applicable safe-isolation and manufacturer's instructions. Record relevant setting values, wiring, mounting and connected equipment. A functional test should demonstrate the intended role of PK7GTA without relying on code appearance alone.
Retain the final PK7GTA designation, the tested configuration and the location in the maintenance record. This allows a later buyer to distinguish the installed item from a similar-looking spare. Any change from PK7GTA should remain traceable to engineering approval.
Look-alike catalogue references
No additional unassigned PK7-pattern code is indexed under PK7GTA. Any proposed alternate still requires its own identity and fit check.
Selection conclusion
Approve PK7GTA only when the verified product facts, installation interface and quotation agree. Keep the complete PK7GTA phrase in the purchase order and acceptance record; do not treat a near-looking designation as interchangeable without manufacturer and engineering evidence.
