BRX184P legacy Berger Lahr explosion-protected servo motor — application and acceptance notes
BRX184P is the exact search and purchasing reference used on this page for the legacy Berger Lahr explosion-protected servo motor. The shared main-image collage represents the product category; it is not an exact photograph of BRX184P. Identify the physical BRX184P item and its environment before committing to a supply order.
Verified technical starting points
| Technical item | Verified value / selection note |
|---|---|
| Enquiry designation | BRX184P |
| Identified role | legacy Berger Lahr explosion-protected servo motor |
| Motor family | BRX18 |
| Nominal torque | 4.5 Nm in manufacturer manual |
| Hazardous-area approval | Verify exact unit ATEX label |
| Configuration boundary | Confirm full label, revision and site compatibility |
The technical table for BRX184P lists only points supported by the cited manufacturer or legacy product material. Any unstated suffix, revision, connector, electrical limit or approval for BRX184P remains an open verification item. Do not infer interchangeability from a similar-looking code.
A four-step buyer checklist
- Confirm the complete code and revision on the installed unit.
- List every required interface, accessory and approval.
- Compare the offered unit or proposed substitute in writing.
- Define receipt inspection and functional acceptance.
Start the BRX184P enquiry with a clear photograph of the nameplate and the original drawing. Include site location, quantity, condition required and delivery constraints. The supplier should quote the complete BRX184P reference and explicitly call out any difference from the installed unit.
System fit and application
The relevant neighbours of BRX184P may include a breaker frame, contactor, cable harness, communication rack, motor, HMI, battery system or software license. For BRX184P, compare the actual interface in the application, not a generic family description. Check the documented voltage, current, mounting and software requirements only where they apply to this legacy Berger Lahr explosion-protected servo motor.
If a later-generation unit is offered in place of BRX184P, require a manufacturer-supported cross-reference or a site engineering comparison. A recommended successor may still need new terminals, commissioning steps or revised approvals. Retain BRX184P in the audit trail even if the approved order uses another code.
Confirm identity, application fit, condition, supplier evidence and receiving plan before order release.
Inspection and handover
When BRX184P arrives, compare the label to the approved purchase record and inspect packaging and fitted accessories. A qualified technician should follow site isolation rules, verify the mechanical and electrical interfaces, and record the appropriate protection, signal, communication or operating test for BRX184P.
File the BRX184P test result, serial or license information and any deviation approval with the equipment record. For a legacy BRX184P unit, separately confirm support status and whether the offered stock is new, used or refurbished. Warranty and acceptance conditions should reflect that distinction.
Visually related model strings
No further unassigned BRX18-pattern code is grouped with BRX184P in this batch. Any alternative still needs a documented comparison to the complete BRX184P requirement.
Decision record
Close the BRX184P enquiry only after the offer, technical comparison and receiving evidence agree. Preserve the exact BRX184P string in the final procurement file and make each accepted substitution explicit.
