9013FSG2J24 pressure-switch setup for water-pump cycling
Schneider Electric 9013FSG2J24 is a Pumptrol pressure switch. This reference page starts with the exact ordering identity and the checks that matter when sourcing 9013FSG2J24 for an existing installation. The shared main collage represents the product category, not a unique photograph of 9013FSG2J24.
Technical data for selection
| Technical item | Verified value / selection note |
|---|---|
| Exact ordering code | 9013FSG2J24 |
| Product family | Pumptrol pressure switch |
| Typical setting | 40–60 psi water-pump range |
| Switch | Two-pole pressure control |
| Enclosure | NEMA 1 class; verify site |
Application fit
This legacy Square D / Telemecanique Sensors reference is a pump pressure switch. Match the pressure range, process connection and electrical load before replacement.
For 9013FSG2J24, compare the exact nameplate, wiring diagram and manufacturer literature before allowing a substitution. A close-looking suffix can change ratings, interface or delivered components.
On-site replacement notes
Record cut-in and cut-out readings with a calibrated gauge. Inspect the tank, piping and motor-control arrangement; a pressure switch alone does not cure rapid cycling caused by the system.
Document the existing 9013FSG2J24 circuit, accessories and setpoints before removing hardware. Use the site's isolation and commissioning procedures, and preserve the approved engineering record.
What to confirm on the installed unit
This legacy Square D / Telemecanique Sensors reference is a pump pressure switch. Match the pressure range, process connection and electrical load before replacement.
The final choice of 9013FSG2J24 depends on the actual installation. Check ambient conditions, available space, mating parts and local electrical requirements rather than inferring fit from appearance.
Before energizing or commissioning
Record cut-in and cut-out readings with a calibrated gauge. Inspect the tank, piping and motor-control arrangement; a pressure switch alone does not cure rapid cycling caused by the system.
After fitting 9013FSG2J24, verify the intended function under representative operating conditions and record the result. A matching code does not eliminate the need for a functional check.
Related ordering codes in the same visual family
No sufficiently similar, unassigned Schneider reference was found for 9013FSG2J24 in this publishing set. Do not substitute an unrelated code simply because its housing resembles 9013FSG2J24.
Purchasing checklist
When requesting 9013FSG2J24, include the exact 9013FSG2J24 label, site voltage, connected equipment, installation photo and required quantity. State whether original 9013FSG2J24 stock or a documented engineering alternative is acceptable. Ask the supplier to confirm current availability, accessories and manufacturer documentation.
Before releasing 9013FSG2J24 to site, compare the delivered full code and terminal/connector arrangement with the approved bill of materials. Keep 9013FSG2J24 associated with its original application and obtain qualified review if any rating, function or lifecycle status differs.
