RPBA-01 technical selection worksheet
Use the complete RPBA-01 designation when requesting this PROFIBUS drive fieldbus adapter. The installation must be checked against the actual equipment marking, because a shared product family does not establish identical ratings, options or approvals.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | RPBA-01 |
| Product family | RPBA-01 |
| Component role | PROFIBUS drive fieldbus adapter |
| Protocol | PROFIBUS DP-V0/DP-V1 |
| Profiles | ABB Drives and PROFIdrive options |
| Drive interface | Check host drive and firmware compatibility |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
This table identifies the published family facts for RPBA-01. Treat any unlisted option as a selection question, not as an implied specification for RPBA-01. Consult the current ABB data and the installed nameplate before release.
Match the ordered configuration
The most important purchase question for RPBA-01 is: Verify drive slot, node address, GSD/profile, bus speed, termination and project mapping. Record any missing suffix, revision, calibration or approval with the supplier.
Ask whether the offered RPBA-01 item includes the required terminals, accessories and documentation. Any suggested substitute needs a line-by-line comparison, not an assumption based on the family prefix.
What the device does
The work assigned to RPBA-01 is specific: Connect the drive to its configured PROFIBUS master and exchange control and diagnostic data. Record the controlled process, feeder or network point in which RPBA-01 operates.
Check the upstream source and the downstream load or signal as a complete path. For RPBA-01, an apparently matching connector or housing does not establish functional equivalence.
Commissioning evidence
The practical acceptance check for RPBA-01 is: Confirm master connection, command/status words, fault recovery and safe operational response. Capture actual readings, states or faults rather than reporting only that the device powered up.
Close the work order for RPBA-01 with the observed test result, final configuration and responsible reviewer. If a safety or protective function is involved, follow the site-specific validation procedure.
Installation boundary
Before fitting RPBA-01, isolate the process or electrical system under the site procedure and check the drawing, connection, mounting and environmental limits.
Document the original terminals and settings for RPBA-01. Reapply only approved wiring and parameter changes; retain the previous unit identification for traceability.
Other codes within this series
The following RPBA-01 designations are grouped on the RPBA-01 page to aid searches and enquiries. They may differ in rating, options, protocol or dimensions. Confirm each full designation before substitution.
- 3ABD64606859 RPBA-01
- RPBA-01 3ABD64606859
- RPBA-01 3AFE64606859
- RPBA-01 64379232
- RPBA-01 64606859
- RPBA-01, 3AFE64504215
Enquiry details to send
Quote RPBA-01 exactly, then state the installed equipment, required quantity, delivery location and whether a new unit or an approved service spare is needed.
For RPBA-01, request the current datasheet, option confirmation and lead time. On receipt, compare the supplied marking to the approved enquiry and retain the commissioning notes with the equipment record.
