Integration notes for ABB PM590-ETH
ABB PM590-ETH is identified here by its complete designation. This page helps align the requested item with its site duty, interfaces and commissioning evidence; a family label alone is insufficient for substitution.
Technical data and configuration boundaries
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | PM590-ETH |
| Product family | PM590-ETH |
| Component role | AC500 PLC CPU with Ethernet |
| Program memory | 2 MB |
| Supply | 24 V DC |
| Interfaces | Ethernet, two configurable RS-232/485 and FBP |
| Order code | 1SAP150000R0271 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Treat the figures and descriptions for PM590-ETH as verified selection references, then check the specific unit nameplate, official drawing and ordered options before installation.
Interface comparison
Before accepting PM590-ETH, compare firmware, terminal base, IP plan, serial peers, power and memory card. A difference in an apparently minor suffix can change the installation or communication behavior.
Photograph the existing PM590-ETH nameplate and connections when possible. Keep the comparison with the work order, including any required adapter or accessory.
Risk and installation controls
An installation involving PM590-ETH should follow the site isolation and permit process. Preserve the approved settings, drawings and test records before removing the old device.
Fit PM590-ETH only after the mechanical, electrical and environmental boundaries are understood. Check protective devices and termination torque against the applicable ABB instructions.
Proof of operation
For the PM590-ETH handover, restore project and test network and I/O handshakes. Document readings, operator observations and any exceptions before normal service is restored.
Archive the final PM590-ETH configuration, software or hardware revision and acceptance sign-off so future maintenance has a trustworthy baseline.
Where this item fits
The practical purpose of PM590-ETH is to execute the assigned PLC project and communications. Identify the plant tag, controlled equipment and operating condition so the request describes a real application rather than a generic spare.
For PM590-ETH, record whether the work is a planned replacement, a new installation or an emergency stock replenishment. Each route changes the evidence needed before release.
Other designations in this family
The following PM590-ETH codes are grouped for search and enquiry with ABB PM590-ETH. They may have different ratings, firmware, approvals or accessories and are not automatically interchangeable.
- PM590-ETH,1SAP150000R0271
Order and service handoff
State the exact ABB PM590-ETH code, plant tag, critical ratings and required documentation on the enquiry. Request confirmation of revision and accessory scope before dispatch.
On receipt, compare PM590-ETH against the approved request and hold any mismatch for engineering review. Keep the tested configuration with the asset record.
