Selection file for ABB PM582-ETH
Use the complete ABB PM582-ETH designation for the purchase and asset record. The short family mark alone cannot establish electrical ratings, process options or interchangeability.
Technical selection record
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | PM582-ETH |
| Product family | PM582-ETH |
| Component role | AC500 PLC CPU with Ethernet |
| CPU | AC500 PM582-ETH |
| Memory | 512 kB |
| Supply | 24 V DC |
| Interfaces | Ethernet plus two configurable RS-232/485 |
| ABB product ID | 1SAP140200R0270 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Values shown for PM582-ETH are selection checkpoints. Confirm the fitted unit, nameplate and ABB documentation before releasing an order or a site change.
Application decision
The intended duty of PM582-ETH is to run the installed AC500 controller program with its local network and serial links. Record the controlled asset, panel location and circuit or process tag next to the exact code.
A specification for PM582-ETH should state the operating conditions rather than assuming another PM582-ETH item is a drop-in replacement.
Fit and interface gate
Compare PM582-ETH with the existing installation for CPU hardware revision, project backup, Ethernet address, serial settings, terminal base and memory card. Keep photos of the nameplate, terminals and accessory arrangement with the enquiry.
If any connector, protective rating or configuration item differs, hold the PM582-ETH substitution for engineering review.
Installation sequence
Before fitting PM582-ETH, isolate the affected system by the plant procedure and preserve the approved settings or wiring schedule. Verify mechanical seating and each identified connection.
After connecting PM582-ETH, check power, communications and local indications before enabling the controlled equipment.
Acceptance evidence
At handover for PM582-ETH, verify program checksum, network peers, serial devices and all assigned I/O. Record who witnessed the test, the measured results and any open action.
The PM582-ETH asset record should retain the final configuration, revision and commissioning evidence for later troubleshooting.
Related configuration codes
Other PM582-ETH designations recorded with PM582-ETH are shown below for search and enquiry. Their options and ratings can differ; the list does not claim automatic interchangeability.
No further unassigned PM582-ETH designation is grouped with PM582-ETH on this page.
Purchase handoff
Quote the complete PM582-ETH designation, the installation tag and the critical interface checks. Ask for nameplate and revision confirmation before dispatch.
When PM582-ETH arrives, compare the received unit to the approved selection record and document the final acceptance result.
