Service and interface record: ABB OTP25T3M(1SCA022401R0090)
Use ABB OTP25T3M(1SCA022401R0090) as the complete reference for this equipment position. Matching a family name alone does not establish module fit, electrical ratings or permitted service configuration.
Technical parameters and limits
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | OTP25T3M(1SCA022401R0090) |
| Product family | OTP25T3M |
| Component role | enclosed three-pole safety disconnect |
| Device | Enclosed switch-disconnector |
| Poles | 3 |
| Class | 25 A designation |
| Enclosure | Plastic enclosure family |
| Order code | 1SCA022401R0090 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
The OTP25T3M(1SCA022401R0090) values above are selection checkpoints. Check the fitted nameplate and current ABB installation documents before releasing a replacement or changing field wiring.
Connection evidence
For OTP25T3M(1SCA022401R0090), inspect load current, cable entries, lockout, IP rating and auxiliary contacts. Verify the exact terminals, power path, mechanical keying and software interface against the site drawing.
If a proposed OTP25T3M(1SCA022401R0090) has different connectors or ratings, stop the swap and document the engineering decision rather than assuming series compatibility.
Asset purpose
ABB OTP25T3M(1SCA022401R0090) is intended to isolate the assigned local equipment through an enclosure. Record the cabinet, circuit or loop tag and the controlled process so the purchase is linked to a defined duty.
A OTP25T3M(1SCA022401R0090) replacement request should identify the installed hardware revision and the reason for change, including any active alarm or failed test.
Diagnostic baseline
For later troubleshooting of OTP25T3M(1SCA022401R0090), capture supply status, module diagnostics, output state and the relevant process reading. This makes it possible to distinguish a device fault from a field issue.
Compare OTP25T3M(1SCA022401R0090) with the pre-change baseline after installation. Investigate unexpected alarms, temperature, noise or switching before returning the asset to normal duty.
Before energizing
Isolate the affected circuit before working on OTP25T3M(1SCA022401R0090), following the plant procedure. Preserve wiring photos, parameters and a known-good diagnostic snapshot.
Seat and terminate OTP25T3M(1SCA022401R0090) with the specified accessories. Check grounding, segregation and installation environment before power is restored.
Acceptance test
For OTP25T3M(1SCA022401R0090), check door and handle operation with the isolated load. Record the result, witness and acceptance date, including any temporary bypass or inhibited alarm that must be removed.
Close the OTP25T3M(1SCA022401R0090) work order only when as-left settings and drawings reflect the actual installation.
Other configuration references
These OTP25T3M references are indexed alongside ABB OTP25T3M(1SCA022401R0090) for enquiry. Different options, ratings or approvals may apply, so the codes are not automatic substitutes.
No additional unassigned OTP25T3M designation is grouped under OTP25T3M(1SCA022401R0090).
Procurement handoff
Quote ABB OTP25T3M(1SCA022401R0090) exactly, including the application tag, required accessories, installation conditions and documentation revision.
At receipt, compare the supplied OTP25T3M(1SCA022401R0090) against the approved code before fitting. Retain the acceptance evidence with the asset record.
