XU9N18PP341WD legacy Telemecanique XU9 photoelectric sensor — full-code comparison for service teams
XU9N18PP341WD identifies this legacy Telemecanique XU9 photoelectric sensor enquiry. A shared category collage is used as a reference image, not as an exact photograph of the supplied XU9N18PP341WD item. Before choosing or replacing XU9N18PP341WD, read the complete physical label and compare it with the system drawings and the relevant manufacturer material.
Technical data confirmed at this stage
| Technical item | Verified value / selection note |
|---|---|
| Complete enquiry wording | XU9N18PP341WD |
| Documented family or role | legacy Telemecanique XU9 photoelectric sensor |
| Sensor family | XU9 photoelectric |
| Exact optical and output mode | Confirm exact datasheet and installed label |
| Unverified option details | Confirm complete order record and received unit |
A family name or shared code prefix does not establish identical ratings, fit or interchangeability.
The table records the evidence available for XU9N18PP341WD. An absent value is deliberately left open. For XU9N18PP341WD, the complete configuration may determine the coil, firmware, process interface, mounting arrangement or protection rating; use the installed XU9N18PP341WD label and full datasheet before approving a purchase.
What to send with a purchase enquiry
- Full nameplate photograph and exact designation
- Equipment drawing, location and installed revision
- Required accessories, connectors, cables and condition
- Acceptance test and delivery requirements
Put XU9N18PP341WD on a separate quotation line and ask the seller to restate the full code. If a different version is proposed for XU9N18PP341WD, request a written matrix comparing ratings, electrical connections, mechanical fit and software or firmware requirements. The buyer should not accept the substitution merely because it belongs to the same family.
Equipment interface review
Review the immediate neighbours of XU9N18PP341WD in the installation. For a breaker or contactor, check pole arrangement, control supply and auxiliary contacts. For a controller or I/O accessory, check rack, baseplate, network and terminal assignment. For a motor or sensor, check feedback, power, cable and mounting. Apply only the categories relevant to the actual XU9N18PP341WD item.
Compare XU9N18PP341WD against the archived wiring and service record. Record any changes in version, communications, calibration or safety approval. A replacement order for XU9N18PP341WD should identify who will verify those changes and what evidence is required at receiving and commissioning.
Receiving and acceptance
On receipt, inspect the packaging and the actual XU9N18PP341WD marking before installation. Keep serial and revision information in the equipment file. Use the site's electrical and process isolation procedure, then test the specific switching, protection, control, measurement or motion function appropriate to XU9N18PP341WD. Record the result rather than relying on a visual match alone.
If XU9N18PP341WD is a legacy item, separately check lifecycle status, condition, warranty and availability of support. If XU9N18PP341WD is offered as refurbished stock, require inspection and test records. If a newer item is offered instead, keep its new designation distinct from XU9N18PP341WD in the approval chain.
Related-looking designations
No further unassigned XU9-pattern code is indexed with XU9N18PP341WD; any alternative still needs manufacturer and site verification.
Release check
Release XU9N18PP341WD only after the complete identification, applicable technical requirements, offer and receiving plan agree. Keep XU9N18PP341WD visible in the final procurement record and document every approved deviation.
