Schneider XSZB118 sensor mounting bracket technical record
Use the full XSZB118 designation when discussing this sensor mounting bracket with a supplier or engineer. The Schneider category main image is a shared reference collage, not an exact photo of XSZB118. The table records limited confirmed facts; the site-specific decision requires the current product document and installed-system information.
Verified technical reference
| Technical item | Verified value / selection note |
|---|---|
| Complete model | XSZB118 |
| Product identity | sensor mounting bracket |
| Component | Mounting bracket |
| Sensor host | 30 mm diameter sensor listing |
| Selection | Confirm sensor geometry |
Where the item fits
The selection question for XSZB118 is not simply whether the code looks familiar. Identify its actual role as sensor mounting bracket, the equipment it connects to, and the site operating conditions. Check sensor body, fixing holes and orientation. Record any missing interface value as a question to verify rather than filling it from a neighboring model.
Keep XSZB118 in the equipment schedule with the intended host, panel or circuit. A shared product picture can show the general category, but it cannot verify terminal layout, voltage, current, firmware or mechanical dimensions of the delivered XSZB118.
Mating and integration checks
Before ordering XSZB118, compare electrical supply, protection, signals or communication settings where relevant. Confirm mechanical installation, mating connector and accessory dependencies. If an engineering drawing refers to another code, obtain an approved cross-reference before substituting XSZB118.
For maintenance replacement, capture the original nameplate and any revision label. Compare the complete string with XSZB118; a changed suffix can alter a component's function. Review thermal, environmental and safety limits with the manufacturer's exact documentation, not with a general family image.
Quotation and receiving controls
Ask for an offer naming XSZB118 exactly, with quantity, destination, lead time and current data sheet. Clarify whether a cable, fuse, mounting part, software or other accessory is included. If XSZB118 is discontinued, ask for a documented alternative and evaluate its differences before purchase.
When XSZB118 arrives, inspect package condition and label. Confirm that the full marking matches the approved order, photograph it and record the supplier's reference. Quarantine a unit labelled differently from XSZB118 until the substitution has been reviewed.
Installation and acceptance
Install XSZB118 under the applicable safe-isolation and manufacturer's instructions. Record relevant setting values, wiring, mounting and connected equipment. A functional test should demonstrate the intended role of XSZB118 without relying on code appearance alone.
Retain the final XSZB118 designation, the tested configuration and the location in the maintenance record. This allows a later buyer to distinguish the installed item from a similar-looking spare. Any change from XSZB118 should remain traceable to engineering approval.
Look-alike catalogue references
No additional unassigned XSZB-pattern code is indexed under XSZB118. Any proposed alternate still requires its own identity and fit check.
Selection conclusion
Approve XSZB118 only when the verified product facts, installation interface and quotation agree. Keep the complete XSZB118 phrase in the purchase order and acceptance record; do not treat a near-looking designation as interchangeable without manufacturer and engineering evidence.
