LC1G8004KUEN product specification and ordering checks for TeSys Giga four-pole contactor
LC1G8004KUEN identifies a particular Schneider Electric TeSys Giga four-pole contactor. This page keeps the exact LC1G8004KUEN designation visible while distinguishing verified product facts from installation decisions. The shared category collage is a reference image and does not claim to depict the exact LC1G8004KUEN configuration.
Verified technical parameters
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | LC1G8004KUEN |
| Product identity | TeSys Giga four-pole contactor |
| Contacts | 4 normally open |
| Conventional AC-1 current | 1050 A at up to 440 V |
| Coil supply | 100–250 V AC/DC |
Selection decision
Confirm the four-pole layout, terminals and AC-1 load rather than assuming an AC-3 motor rating.
For LC1G8004KUEN, record the existing equipment tag, supply, load, mounting and mating accessories. Compare each item with the verified parameters above and the current manufacturer documentation for LC1G8004KUEN. A code with a similar prefix may change the electrical or mechanical specification.
What to inspect before ordering
Start with a photograph of the complete LC1G8004KUEN label and the installed connections. For LC1G8004KUEN, check the exact suffix, terminal layout, protective device or controller pairing, and the available panel space. Where the application uses a safety function, a qualified engineer must validate the whole function.
The purchase description should retain LC1G8004KUEN exactly. Include the equipment ID and any separate accessory codes; a shared picture or family name does not prove that the delivered LC1G8004KUEN includes every part of an assembly.
Field verification after fitting
Isolate the equipment according to site procedure before installing LC1G8004KUEN. Preserve settings, wiring labels and software backups where they apply. For LC1G8004KUEN, verify supply and signal values, operating states and alarms in a safe test condition.
Record the delivered LC1G8004KUEN on the commissioning sheet. If a proposed replacement differs from LC1G8004KUEN, document the difference and obtain engineering approval before energising the equipment.
Related-looking designations in this catalog
The 30 designations below share the visible LC1G code pattern with LC1G8004KUEN. They are listed here as related references and will not receive separate pages in this publishing set. Their similar appearance does not establish interchangeability with LC1G8004KUEN; compare each complete rating and option.
Order release record
Release LC1G8004KUEN only after checking the current Schneider Electric datasheet, the delivered nameplate, site conditions and any applicable regional lifecycle notice. Keep the LC1G8004KUEN selection record with the test results so future service teams can trace the decision.
