Technical identification of DOMD01625 for Schneider equipment
DOMD01625 is treated here as a precise enquiry designation for the Domae residual-current circuit breaker with overcurrent protection. The shared category image is a visual reference, not a photograph of the exact DOMD01625 configuration. Confirm the ordered version against the installed label before treating an illustration or shortened description as product evidence.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | DOMD01625 |
| Product identity | Domae residual-current circuit breaker with overcurrent protection |
| Poles | 1P + N |
| Rated current | 25 A |
| Trip characteristics | C curve; 30 mA residual sensitivity; type AC |
| Breaking capacity | 6000 A in the manufacturer listing |
| Required site confirmation | Nameplate, revision, connection, mounting and application drawing |
Application boundary
Start with the actual job of DOMD01625 in the equipment. Record the supply or signal path, the connected load or network, installation position, and applicable site drawing. The purpose of this check is to keep the DOMD01625 enquiry tied to the installed system rather than a similar-looking catalog item.
Where the DOMD01625 designation is abbreviated or derived from a replacement listing, do not silently extend it to a complete ordering code. Ask for a photograph of the original rating plate and an offer that shows the full manufacturer's designation. A purchase description should state unresolved options explicitly.
Buyer verification sequence
Check the DOMD01625 electrical interface against the existing installation: supply, signal, bus or protection requirements as relevant to this item. Identify connected accessories and downstream devices. For any proposed substitution for DOMD01625, obtain written confirmation of interface and approval differences before release.
Review the mechanical fit of DOMD01625 including panel space, rail or rack position, terminal access, cable bend radius, environmental exposure and service clearance. These checks are especially important when an older DOMD01625 unit is replaced from remaining stock or a different production revision.
Require exact code, condition, origin, revision, included accessories, warranty terms and a documented acceptance route.
Receiving and commissioning
On delivery, match the DOMD01625 nameplate with the purchase order. Inspect packaging, connector keys, terminals and signs of repair. Photograph any discrepancy and hold installation until the responsible engineer determines whether the delivered DOMD01625 is acceptable.
Qualified personnel should isolate the circuit or system before work on DOMD01625, follow the manufacturer instructions, and test the actual application after installation. Log the final configuration, measured result and any firmware or parameter backup so that future maintenance staff can trace the DOMD01625 decision.
Related-code enquiry scope
No additional unassigned DOMD code is included with DOMD01625 here. This is an editorial grouping boundary, not a claim that DOMD01625 has no other variants or replacement candidates.
Decision record
Keep the DOMD01625 manufacturer evidence, installed label, quotation and acceptance result together. If the proposed DOMD01625 supply lacks one of these items, flag the gap in the enquiry and obtain the missing confirmation before purchase or installation.
For a maintenance replacement, state why DOMD01625 matches the equipment and what remains conditional. Technical approval belongs to the site engineer; this page helps a buyer collect the facts needed to make that approval traceable.
