Schneider C1BN2TM10HD ComPacT NSX DC circuit breaker technical record
Use the full C1BN2TM10HD designation when discussing this ComPacT NSX DC circuit breaker with a supplier or engineer. The Schneider category main image is a shared reference collage, not an exact photo of C1BN2TM10HD. The table records limited confirmed facts; the site-specific decision requires the current product document and installed-system information.
Verified technical reference
| Technical item | Verified value / selection note |
|---|---|
| Complete model | C1BN2TM10HD |
| Product identity | ComPacT NSX DC circuit breaker |
| Frame | NSX1200N DC |
| Poles | 2 |
| Trip unit | TM-DC 1000 A |
| Breaking rating listing | 50 kA at 600 V DC |
| Bare-cable connector | Not included in listing |
Where the item fits
The selection question for C1BN2TM10HD is not simply whether the code looks familiar. Identify its actual role as ComPacT NSX DC circuit breaker, the equipment it connects to, and the site operating conditions. Verify DC fault duty, polarity and termination kit. Record any missing interface value as a question to verify rather than filling it from a neighboring model.
Keep C1BN2TM10HD in the equipment schedule with the intended host, panel or circuit. A shared product picture can show the general category, but it cannot verify terminal layout, voltage, current, firmware or mechanical dimensions of the delivered C1BN2TM10HD.
Mating and integration checks
Before ordering C1BN2TM10HD, compare electrical supply, protection, signals or communication settings where relevant. Confirm mechanical installation, mating connector and accessory dependencies. If an engineering drawing refers to another code, obtain an approved cross-reference before substituting C1BN2TM10HD.
For maintenance replacement, capture the original nameplate and any revision label. Compare the complete string with C1BN2TM10HD; a changed suffix can alter a component's function. Review thermal, environmental and safety limits with the manufacturer's exact documentation, not with a general family image.
Quotation and receiving controls
Ask for an offer naming C1BN2TM10HD exactly, with quantity, destination, lead time and current data sheet. Clarify whether a cable, fuse, mounting part, software or other accessory is included. If C1BN2TM10HD is discontinued, ask for a documented alternative and evaluate its differences before purchase.
When C1BN2TM10HD arrives, inspect package condition and label. Confirm that the full marking matches the approved order, photograph it and record the supplier's reference. Quarantine a unit labelled differently from C1BN2TM10HD until the substitution has been reviewed.
Installation and acceptance
Install C1BN2TM10HD under the applicable safe-isolation and manufacturer's instructions. Record relevant setting values, wiring, mounting and connected equipment. A functional test should demonstrate the intended role of C1BN2TM10HD without relying on code appearance alone.
Retain the final C1BN2TM10HD designation, the tested configuration and the location in the maintenance record. This allows a later buyer to distinguish the installed item from a similar-looking spare. Any change from C1BN2TM10HD should remain traceable to engineering approval.
Look-alike catalogue references
No additional unassigned C1BN-pattern code is indexed under C1BN2TM10HD. Any proposed alternate still requires its own identity and fit check.
Selection conclusion
Approve C1BN2TM10HD only when the verified product facts, installation interface and quotation agree. Keep the complete C1BN2TM10HD phrase in the purchase order and acceptance record; do not treat a near-looking designation as interchangeable without manufacturer and engineering evidence.
