BRS368W130ABA technical identity and replacement considerations for Lexium three-phase stepper motor
BRS368W130ABA is the complete ordering reference for a Schneider Electric Lexium three-phase stepper motor. This page identifies the confirmed characteristics of BRS368W130ABA and the practical fit checks for an existing installation. The shared category collage is a reference image, not an exact photograph of BRS368W130ABA.
Technical parameters and confirmed identity
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | BRS368W130ABA |
| Product type | Lexium three-phase stepper motor |
| Holding torque | 1.7 Nm |
| Shaft | 8 mm diameter |
| Length | 79 mm; no brake |
What the code identifies
The BRS368W130ABA designation identifies the part above, not every accessory in the complete system. Purchase and maintenance records should retain the exact BRS368W130ABA characters, including any suffix. Where a similar-looking reference exists, compare its full specification rather than treating it as an automatic replacement.
For BRS368W130ABA, the parameter table separates product identity from site-specific engineering decisions. Ratings in a family brochure may cover several variants; the installed BRS368W130ABA nameplate and current manufacturer data remain the final order check.
Application fit and engineering boundaries
Check driver matching, shaft coupling, mounting and terminal-box orientation.
Before accepting BRS368W130ABA, compare the existing panel or machine drawing with the relevant voltage, current, contact, network, pressure or mechanical interface noted for this product. Record cable entry, mounting space, connected load and environmental conditions where applicable.
A procurement request for BRS368W130ABA should state the equipment tag and purpose, not just the part number. If the original unit has options or accessories, list them separately; a replacement BRS368W130ABA may not include those items.
Installation and functional record
Qualified personnel should isolate the equipment under the site's procedure before fitting BRS368W130ABA. Photograph the original connections, label conductors, and retain any software or parameter backup relevant to BRS368W130ABA.
After installation of BRS368W130ABA, test the operating sequence in a safe state. Record measured supply or signal values, status indications, alarms and the final BRS368W130ABA reference on the handover sheet.
If BRS368W130ABA is a safety, protection or switching component, complete the application-specific coordination and validation process. The information here is not a substitute for the machine risk assessment or electrical design review.
Similar-looking codes covered by this page
The following codes resemble BRS368W130ABA and are grouped here as reference variants, so they are not scheduled as separate product pages. Similar spelling does not mean electrical or mechanical interchangeability. Compare each full code, option and rating to BRS368W130ABA.
Order release checklist
For BRS368W130ABA, confirm the full designation, the actual installed interface, the rating or setting in the table, and the availability of any required mating part. Mark any deviation from the original BRS368W130ABA installation for engineering review.
The final BRS368W130ABA selection should be checked against current Schneider Electric product documentation and the delivered device label. Preserve the commissioning record with the order so future BRS368W130ABA service decisions remain traceable.
Additional similar-looking designations
BRS motion-control designations are indexed here for search and enquiry. They may designate different hardware, functions or configurations and are not automatically interchangeable. Check each exact reference, rating and manufacturer record.
