BMXFCA152 purchasing and commissioning guide
BMXFCA152 is the complete Schneider Electric ordering designation for the Modicon X80 preformed I/O cordset. The category main image is a shared reference collage, not an exact photograph of BMXFCA152. The points below separate manufacturer-supported specifications from site-specific choices.
Technical parameters
| Technical item | Verified value / selection note |
|---|---|
| Complete model | BMXFCA152 |
| Product identity | Modicon X80 preformed I/O cordset |
| Length | 1.5 m |
| Module end | 40-way connector |
| Sub-base end | SUB-D 25 |
What does BMXFCA152 identify?
The BMXFCA152 code identifies the product type and variant described in the table. Keep every character of BMXFCA152 in purchasing and maintenance records. A partial code or similar photograph cannot establish an exact replacement.
Which application checks matter for BMXFCA152?
Compare the module and Telefast sub-base references before rewiring.
Before releasing BMXFCA152, compare the installed supply, load, enclosure, terminals, network or mechanical interface as applicable. Match the actual BMXFCA152 nameplate and panel drawing to the current manufacturer data. Include any required accessory as a separate line item.
How should BMXFCA152 be installed and tested?
Qualified personnel should isolate the equipment under site procedure, record the original wiring and configuration, then fit BMXFCA152 according to the relevant instructions. Preserve any software backup or settings associated with BMXFCA152.
After installation, test the intended operating sequence and record measured values, indications, alarms and the delivered BMXFCA152 reference. For a protection or safety component, BMXFCA152 must be validated within the complete application; the part code alone does not prove compliance.
Related-looking codes grouped with this representative
These 31 unassigned codes share the visible BMXF pattern with BMXFCA152. They are included on this representative page and are not queued as separate product pages. Their technical specifications may differ from BMXFCA152; check the full code before substitution.
Final procurement note
Confirm the availability and regional lifecycle of BMXFCA152, the current datasheet revision and the delivered label. Keep the BMXFCA152 selection decision with the installation record so a later service team can reconstruct why this exact item was ordered.
