BMI1003P07F Lexium BMI integrated servo motor and its verified selection points
The full designation BMI1003P07F identifies the requested Lexium BMI integrated servo motor. This record separates confirmed catalogue information from project-specific checks. The shared Schneider category image is a reference collage, not a photograph of the exact BMI1003P07F variant.
Technical parameters and identity
| Technical item | Verified value / selection note |
|---|---|
| Complete model | BMI1003P07F |
| Product identity | Lexium BMI integrated servo motor |
| Motor | Three-phase servo motor |
| Encoder | Absolute multiturn SinCos Hiperface |
| Brake | Brake configuration in listed designation |
| Protection | IP54 listing |
Interface review
Start the BMI1003P07F review at the interface it connects to: the host assembly, electrical supply, mating device or mechanical opening. Confirm drive, encoder, brake and mechanical coupling. Do not infer the missing interface details from a short code or the category image.
For BMI1003P07F, record the existing installed marking and the intended location. Compare the full manufacturer's designation, mounting method, terminals, ratings and applicable standards. A visually similar code may differ in an option that changes the installation decision.
Documentation requested with a quotation
Ask the supplier to quote exactly BMI1003P07F and provide the current manufacturer data sheet, installation instructions and any relevant dimensional drawing. State the destination country and quantity. If BMI1003P07F is discontinued or regional, ask for availability and a documented alternative rather than assuming stock.
For a proposed replacement of BMI1003P07F, require a written cross-reference. Compare every affected rating and interface with the original engineering requirement before substituting. The presence of another number in the same visual family is not evidence of equivalence.
Installation and commissioning record
Before installing BMI1003P07F, check the delivered label, package condition and included accessories against the approved order. Keep a photo of the marking, the wiring or assembly diagram, and the equipment tag. Follow the product instructions for safe isolation and torque or mounting requirements.
After fitting BMI1003P07F, document the relevant functional test: operation, indication, protective coordination, communication or mechanical movement as applicable. Record any difference between the planned BMI1003P07F and the actual supplied designation.
Visually similar catalogue codes
No remaining unassigned BMI-pattern designation is grouped with BMI1003P07F. Similar appearance alone should never replace a technical comparison.
Buyer decision
Approve BMI1003P07F only after the confirmed parameters above and the project-specific interface checks are reconciled. In particular, identify the supply, protection, mounting and mating accessories that apply to BMI1003P07F; not all of these can be inferred from the designation alone.
Keep the final approved BMI1003P07F designation on the procurement and receiving documents. If an alternative arrives, quarantine the change for engineering review before it is installed or energized.
