ABL1REM24062 technical identity and replacement considerations for Phaseo regulated switch-mode power supply
ABL1REM24062 is the complete ordering reference for a Schneider Electric Phaseo regulated switch-mode power supply. This page identifies the confirmed characteristics of ABL1REM24062 and the practical fit checks for an existing installation. The shared category collage is a reference image, not an exact photograph of ABL1REM24062.
Technical parameters and confirmed identity
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | ABL1REM24062 |
| Product type | Phaseo regulated switch-mode power supply |
| Input | 100–240 V AC, single phase |
| Output | 24 V DC, 6.2 A |
| Rated power | 150 W |
What the code identifies
The ABL1REM24062 designation identifies the part above, not every accessory in the complete system. Purchase and maintenance records should retain the exact ABL1REM24062 characters, including any suffix. Where a similar-looking reference exists, compare its full specification rather than treating it as an automatic replacement.
For ABL1REM24062, the parameter table separates product identity from site-specific engineering decisions. Ratings in a family brochure may cover several variants; the installed ABL1REM24062 nameplate and current manufacturer data remain the final order check.
Application fit and engineering boundaries
Check the 24 V load budget and supply derating before replacing a cabinet power unit.
Before accepting ABL1REM24062, compare the existing panel or machine drawing with the relevant voltage, current, contact, network, pressure or mechanical interface noted for this product. Record cable entry, mounting space, connected load and environmental conditions where applicable.
A procurement request for ABL1REM24062 should state the equipment tag and purpose, not just the part number. If the original unit has options or accessories, list them separately; a replacement ABL1REM24062 may not include those items.
Installation and functional record
Qualified personnel should isolate the equipment under the site's procedure before fitting ABL1REM24062. Photograph the original connections, label conductors, and retain any software or parameter backup relevant to ABL1REM24062.
After installation of ABL1REM24062, test the operating sequence in a safe state. Record measured supply or signal values, status indications, alarms and the final ABL1REM24062 reference on the handover sheet.
If ABL1REM24062 is a safety, protection or switching component, complete the application-specific coordination and validation process. The information here is not a substitute for the machine risk assessment or electrical design review.
Similar-looking codes covered by this page
The following codes resemble ABL1REM24062 and are grouped here as reference variants, so they are not scheduled as separate product pages. Similar spelling does not mean electrical or mechanical interchangeability. Compare each full code, option and rating to ABL1REM24062.
Order release checklist
For ABL1REM24062, confirm the full designation, the actual installed interface, the rating or setting in the table, and the availability of any required mating part. Mark any deviation from the original ABL1REM24062 installation for engineering review.
The final ABL1REM24062 selection should be checked against current Schneider Electric product documentation and the delivered device label. Preserve the commissioning record with the order so future ABL1REM24062 service decisions remain traceable.
