ABB 1SDA073776R1 specification for the actual host

ABB 1SDA073776R1 is the complete order identity for the breaker position-contact accessory considered here. The purpose is to report the approved breaker operating position. The shared category photograph is illustrative; inspect the supplied ABB 1SDA073776R1 marking before acceptance.

Technical parameters and version boundary

The ABB 1SDA073776R1 values above identify the manufacturer-stated designation. Confirm all host-specific limits from the ABB 1SDA073776R1 instructions and installed-equipment record before treating a neighboring code as a substitute.

Installed equipment record

For ABB 1SDA073776R1, record the breaker or drive type, hardware revision, wiring drawing and the existing part marking. Match the complete ABB 1SDA073776R1 code, not just the family name.

Photograph the ABB 1SDA073776R1 connection or mounting position and note the asset number. This makes a later replacement or fault investigation traceable.

Selection gate

The controlling fit check for ABB 1SDA073776R1 is S51 host frame, wiring and contact function. Compare this directly with the supplied part and the approved bill of materials.

If an ABB 1SDA073776R1 variant differs in frame, voltage, slots, contacts or firmware, stop the substitution until engineering approves that specific variant.

Electrical and mechanical interface

Inspect ABB 1SDA073776R1 connectors, terminal designations, clearances and mounting features against the host instructions. Do not force an ABB 1SDA073776R1 part into a similar-looking assembly.

Where ABB 1SDA073776R1 carries a rated voltage, current or communication speed in the designation, confirm that the installed circuit is within the exact product limit.

Receiving and storage

On arrival, compare ABB 1SDA073776R1 with the purchase order, ABB label and quantity. Check seals, contacts, board edges or mechanical pieces as appropriate to the part type.

Store ABB 1SDA073776R1 under the conditions specified for its product family; protect electronics from static discharge and keep safety-related accessories with their identification.

Preparation for replacement

Before work on ABB 1SDA073776R1, isolate the relevant energy sources and follow the applicable site procedure. Capture configuration, wiring and original settings where the ABB 1SDA073776R1 role requires them.

Use the ABB 1SDA073776R1 host manual to confirm installation order, accessory compatibility, torque and protective covers before energizing.

Functional acceptance

After ABB 1SDA073776R1 has been installed, verify position feedback in each specified state. Check the normal state and an appropriate alternate or fault state under the approved commissioning procedure.

Record ABB 1SDA073776R1 results, any parameter changes, residual alarms and the person approving return to service.

Future spare identification

Keep ABB 1SDA073776R1 in the asset spare list with the full order code, supported host and variant restrictions. A shorthand name can hide important technical differences.

For future enquiries, send the ABB 1SDA073776R1 designation together with a nameplate photo and the installation record so the exact replacement can be confirmed.

Related ABB codes in this product series

The following listed codes are represented on this ABB 1SDA073776R1 page and are not separate product pages. Check the complete code for every voltage, host, contact, function or board revision before ordering; membership in the same series is not proof of interchangeability.

• 1SDA073776R1 S51 250V E1.2/3-XT7-XT7M
• 1SDA073778R1

Procurement handover

Include ABB 1SDA073776R1 and the verified host in the final spare-parts request.

Retain the ABB 1SDA073776R1 receipt and commissioning result with the equipment history.