Danfoss 061H3008 RGE control for pressure-dependent condenser fan speed
Danfoss 061H3008 identifies a RGE-Z1P4-7DS fan-speed controller. The technical data below follows the cited manufacturer record for this exact code. The shared main image is a category reference and not a photograph of the exact Danfoss 061H3008 item.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete order number | 061H3008 |
| Manufacturer / item class | Danfoss RGE-Z1P4-7DS fan-speed controller |
| Manufacturer type | RGE-Z1P4-7DS |
| Factory pressure setting | 19 bar in manufacturer table |
| Adjustment range | 8–28 bar |
| Motor current range | 0.2–6 A in manufacturer table |
| Image scope | Shared Danfoss category collage, not exact-item photograph |
| Final selection rule | Verify complete printed code, interface and application before substitution |
Control duty
For Danfoss 061H3008, verify the condenser pressure and approved refrigerant before using the RGE pressure-control range.
Fan motor interface
For Danfoss 061H3008, compare motor current, phase and supply wiring with the installed controller; do not infer fit from the enclosure alone.
Operating test
For Danfoss 061H3008, observe fan-speed response as condensing pressure changes and verify safe behavior at the minimum-speed setting.
Similar-looking Danfoss order references
These order strings resemble Danfoss 061H3008 visually and are listed for enquiry searches only. They can have different functions, ratings or connections. They are not automatic alternatives to Danfoss 061H3008; verify each complete code independently.
Ordering and receiving review
Request a quotation against the full Danfoss 061H3008 code and the installed equipment record. Check manufacturer status, pack quantity and all relevant electrical or process interfaces. An offer based only on a similar-looking model number requires a separate technical comparison.
When Danfoss 061H3008 arrives, inspect the label and supplied connections before installation. Record the installed setting, configuration or functional test result so future service enquiries retain the exact Danfoss 061H3008 identity.
