low voltage

Hotline

Danfoss 031E020566 CS Pressure Switch | 2–6 bar Range, TPST Contact and IP55 Housing Check

description:Danfoss 031E020566 CS pressure switch: verified technical data, selection checks and similar-looking order references....
BASIC INFO

Danfoss 031E020566 CS switch for pressure-controlled equipment

Danfoss 031E020566 identifies a CS pressure switch. The technical data below follows the cited manufacturer record for this exact code. The shared main image is a category reference and not a photograph of the exact Danfoss 031E020566 item.

Key technical data

Technical itemVerified value / selection note
Complete order number031E020566
Manufacturer / item classDanfoss CS pressure switch
Regulation range2–6 bar Pe
Contact / resetTPST / automatic reset
Pressure fittingG 1/4 female
Enclosure / working pressureIP55 / 6 bar maximum working pressure
Image scopeShared Danfoss category collage, not exact-item photograph
Final selection ruleVerify complete printed code, interface and application before substitution

Pressure duty

For Danfoss 031E020566, compare the desired cut-in and cut-out settings with the published adjustment and working-pressure limits.

Electrical wiring

For Danfoss 031E020566, check the installed TPST circuit and cable entry rather than assuming an SPDT replacement will fit.

Acceptance test

For Danfoss 031E020566, verify contact action through a controlled pressure cycle and document the final setting.

Similar-looking Danfoss order references

These order strings resemble Danfoss 031E020566 visually and are listed for enquiry searches only. They can have different functions, ratings or connections. They are not automatic alternatives to Danfoss 031E020566; verify each complete code independently.

031E021566
031E023566

Ordering and receiving review

Request a quotation against the full Danfoss 031E020566 code and the installed equipment record. Check manufacturer status, pack quantity and all relevant electrical or process interfaces. An offer based only on a similar-looking model number requires a separate technical comparison.

When Danfoss 031E020566 arrives, inspect the label and supplied connections before installation. Record the installed setting, configuration or functional test result so future service enquiries retain the exact Danfoss 031E020566 identity.

 

 

Pre:Danfoss 023U1921 DCR 48-F Strainer Core | 48 cu.in. Filter-Drier Spare-Part Selection Next:Danfoss 060N1004 MBS 5100 Pressure Transmitter | 0–40 bar Range and Marine-Sensor Selection