Identifying encoder 269813-100077 before a PROFINET replacement
The Pepperl+Fuchs 269813-100077 reference describes a multiturn absolute encoder. This service-oriented page keeps 269813-100077 as the search and ordering key, while ENA58IL-S10CA7-1213B17-RH2 is the complete manufacturer-format identity to compare with the installed label. The shared Pepperl+Fuchs montage is only a category illustration, not a product-specific photograph of 269813-100077.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Exact model | 269813-100077 |
| Product role | multiturn absolute encoder |
| Manufacturer ordering reference | 269813-100077 |
| Complete type | ENA58IL-S10CA7-1213B17-RH2 |
| Encoder family | ENA58IL absolute encoder |
| Network family | PROFINET-listed variant; verify exact configuration and firmware |
| Variant check | Confirm the complete designation and current manufacturer documentation before replacement. |
Operating boundary
For 269813-100077, establish the as-installed boundary first: mounting, electrical or mechanical interface, environmental conditions, approved drawing and maintenance history. 269813-100077 is intended to report shaft position to a compatible industrial network controller. A similar-looking code is not automatically an electrical, dimensional or certified replacement. Resolve every conflicting suffix against current maker documentation before an order is placed.
Receiving and identification
Receiving inspection for 269813-100077 begins with the carton and unit marking. Record the complete ENA58IL-S10CA7-1213B17-RH2 designation, visible damage, any accessory supplied and the relevant batch or serial reference. Compare these with the purchase specification for 269813-100077. Isolate the system before handling, and preserve configuration settings or wiring photographs from the outgoing unit.
Mechanical and signal interface
Mechanical fit for 269813-100077 must be confirmed independently of the image. Check fixing centres, shaft or enclosure clearances where applicable, cable entry orientation and the final connection arrangement. Electrical or signal fit must include supply, polarity, interface and the host's expected behaviour. For 269813-100077, a connector that mates physically is not proof of correct operation.
Approval review
Where the 269813-100077 installation is subject to hazardous-area or safety rules, verify the exact certificate, approved accessory combination and site procedure. Record the nameplate and drawing used for that check. Do not transfer an approval from another multiturn absolute encoder solely because it resembles 269813-100077. If the documented limits cannot be matched, keep the item out of service until engineering review.
Functional acceptance
Commissioning of 269813-100077 should verify a known baseline and a deliberate changed state. Record the controller indication, alarm response and mechanical security, then repeat after final fixing. The 269813-100077 handover package should contain the selected ENA58IL-S10CA7-1213B17-RH2 documentation, as-built connection record and test result. This gives the next maintenance team a defensible basis for future replacement.
Ordering record
A request for 269813-100077 should include the exact printed code, the complete type ENA58IL-S10CA7-1213B17-RH2, quantity and the host or installed assembly. Ask the supplier to confirm the full designation and current data sheet. Keep 269813-100077 visible in the purchasing record rather than shortening it to a generic family name, because a small code difference can change the physical or electrical interface.
Related-model note
No unverified look-alike designation is claimed interchangeable with 269813-100077. Confirm every proposed alternative on its own complete technical record.
