Asset and application profile: ABB V18341-A10131021
ABB V18341-A10131021 is identified here by its complete designation. This page helps align the requested item with its site duty, interfaces and commissioning evidence; a family label alone is insufficient for substitution.
Technical data and configuration boundaries
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | V18341-A10131021 |
| Product family | V18341 |
| Component role | TZID electro-pneumatic positioner |
| Family | TZID |
| Function | Intelligent electro-pneumatic positioning |
| Signal | 4–20 mA two-wire family interface |
| Configuration | Confirm fitted options and approval |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Treat the figures and descriptions for V18341-A10131021 as verified selection references, then check the specific unit nameplate, official drawing and ordered options before installation.
Interface comparison
Before accepting V18341-A10131021, compare actuator action, air, mounting, travel sensor and loop power. A difference in an apparently minor suffix can change the installation or communication behavior.
Photograph the existing V18341-A10131021 nameplate and connections when possible. Keep the comparison with the work order, including any required adapter or accessory.
Risk and installation controls
An installation involving V18341-A10131021 should follow the site isolation and permit process. Preserve the approved settings, drawings and test records before removing the old device.
Fit V18341-A10131021 only after the mechanical, electrical and environmental boundaries are understood. Check protective devices and termination torque against the applicable ABB instructions.
Proof of operation
For the V18341-A10131021 handover, verify end stops, travel and response to setpoint steps. Document readings, operator observations and any exceptions before normal service is restored.
Archive the final V18341-A10131021 configuration, software or hardware revision and acceptance sign-off so future maintenance has a trustworthy baseline.
Where this item fits
The practical purpose of V18341-A10131021 is to position the legacy valve assembly with the specified TZID device. Identify the plant tag, controlled equipment and operating condition so the request describes a real application rather than a generic spare.
For V18341-A10131021, record whether the work is a planned replacement, a new installation or an emergency stock replenishment. Each route changes the evidence needed before release.
Other designations in this family
The following V18341 codes are grouped for search and enquiry with ABB V18341-A10131021. They may have different ratings, firmware, approvals or accessories and are not automatically interchangeable.
No additional unassigned V18341 code is grouped under V18341-A10131021 at present.
Order and service handoff
State the exact ABB V18341-A10131021 code, plant tag, critical ratings and required documentation on the enquiry. Request confirmation of revision and accessory scope before dispatch.
On receipt, compare V18341-A10131021 against the approved request and hold any mismatch for engineering review. Keep the tested configuration with the asset record.
