Integration notes for ABB SACE E2S/MS 20
ABB SACE E2S/MS 20 is identified here by its complete designation. This page helps align the requested item with its site duty, interfaces and commissioning evidence; a family label alone is insufficient for substitution.
Technical data and configuration boundaries
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | SACE E2S/MS 20 |
| Product family | SACE E2S/MS |
| Component role | Emax switch-disconnector |
| Device | Switch-disconnector, not an automatic circuit breaker |
| Frame | E2S/MS 20 |
| Rated current | 2000 A at 40 °C family reference |
| Short-time withstand | 65 kA for 1 s family reference |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Treat the figures and descriptions for SACE E2S/MS 20 as verified selection references, then check the specific unit nameplate, official drawing and ordered options before installation.
Where this item fits
The practical purpose of SACE E2S/MS 20 is to provide the specified switching and isolation point. Identify the plant tag, controlled equipment and operating condition so the request describes a real application rather than a generic spare.
For SACE E2S/MS 20, record whether the work is a planned replacement, a new installation or an emergency stock replenishment. Each route changes the evidence needed before release.
Interface comparison
Before accepting SACE E2S/MS 20, compare poles, fixed or drawout construction, busbars, interlocks and upstream protection. A difference in an apparently minor suffix can change the installation or communication behavior.
Photograph the existing SACE E2S/MS 20 nameplate and connections when possible. Keep the comparison with the work order, including any required adapter or accessory.
Proof of operation
For the SACE E2S/MS 20 handover, witness mechanical operation and isolation status. Document readings, operator observations and any exceptions before normal service is restored.
Archive the final SACE E2S/MS 20 configuration, software or hardware revision and acceptance sign-off so future maintenance has a trustworthy baseline.
Risk and installation controls
An installation involving SACE E2S/MS 20 should follow the site isolation and permit process. Preserve the approved settings, drawings and test records before removing the old device.
Fit SACE E2S/MS 20 only after the mechanical, electrical and environmental boundaries are understood. Check protective devices and termination torque against the applicable ABB instructions.
Other designations in this family
The following SACE E2S/MS codes are grouped for search and enquiry with ABB SACE E2S/MS 20. They may have different ratings, firmware, approvals or accessories and are not automatically interchangeable.
No additional unassigned SACE E2S/MS code is grouped under SACE E2S/MS 20 at present.
Order and service handoff
State the exact ABB SACE E2S/MS 20 code, plant tag, critical ratings and required documentation on the enquiry. Request confirmation of revision and accessory scope before dispatch.
On receipt, compare SACE E2S/MS 20 against the approved request and hold any mismatch for engineering review. Keep the tested configuration with the asset record.
