Technical review before ordering OS160GD03P
The full OS160GD03P marking belongs on the enquiry and the receiving inspection. OS160GD03P is a three-pole fuse switch-disconnector whose suitability depends on the actual connected process, circuit or control project.
Technical parameters
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | OS160GD03P |
| Product family | OS160 |
| Component role | three-pole fuse switch-disconnector |
| Rated current | 160 A class |
| Poles | 3 |
| Fuse sizes | 000 / 00; confirm fuse-link design |
| Order code | 1SCA115399R1001 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Read these OS160GD03P parameters together with the nameplate and the manufacturer's option data. The short family label does not establish every rating or installed accessory.
Questions for the quotation
Ask the supplier to confirm this OS160GD03P match: Check fuse type and rating, utilization category, handle/shaft kit, door interlock and conductor termination. Attach the installed full code and relevant drawings to the enquiry.
A similar item is not automatically equivalent to OS160GD03P. Ask for a written comparison of ratings, interfaces, terminals, dimensions, options and required firmware or settings.
How to prepare the replacement
Before working on OS160GD03P, follow the plant's isolation or process-shutdown procedure. Photograph or record terminal positions, accessory parts, settings and current indications.
For OS160GD03P, compare the delivered identification with the approved order. Fit only the required components and restore an approved backup rather than recreating settings from memory.
Application snapshot
The intended function of OS160GD03P is: Provide manual isolation and fuse-link protection at the specified distribution point. Record the real process or electrical duty and the equipment that sends or receives the signal.
For OS160GD03P, note any site condition that changes selection: mounting position, ambient temperature, load profile, supply quality, hazardous-area conditions or the existing communication project.
What to observe on startup
The acceptance test for OS160GD03P is: Confirm fuse seating, operating positions and isolation under the site switching procedure. Compare measured results and indications with the commissioning record.
If OS160GD03P forms part of a protective function, verify fault response and reset in addition to normal operation. Keep the final readings and sign-off with the maintenance file.
Other designations in this family
The following OS160 codes are gathered with OS160GD03P for search and purchase enquiries. They can differ in sensor, coil, rating, pole count, communication or accessories. Check each complete code; they are not automatically direct replacements.
- OS160GD12
Receiving checklist
When OS160GD03P arrives, compare the marked code, revision and included accessories with the order. Record any variance before the equipment is installed.
Retain the OS160GD03P technical document, inspection and commissioning result with the asset record so the next replacement can be matched accurately.
