1SAE351111R0140 ESB63-40N-01: four-pole layout and 24 V AC/DC control review
ABB's installation-contactor ordering table identifies ESB63-40N-01 as a four-normally-open-pole, 63 A AC-1/AC-7a device with a 24 V AC/DC control circuit. The listed order code is 1SAE351111R0140.
Verified identification and technical data
| Technical item | Verified value / selection note |
|---|---|
| ABB order code | 1SAE351111R0140 |
| Type | ESB63-40N-01 |
| Main contact arrangement | 4 normally open poles |
| Rated AC-1 / AC-7a class | 63 A |
| Control voltage | 24 V AC/DC for -01 code |
| DIN modular width | 3 module spacings |
| Application | Single- or three-phase load switching |
For 1SAE351111R0140 ESB63-40N-01, the table is an identification and selection aid. A nameplate, ABB order record and the actual installation still govern the final configuration.
Confirm the full type, revision and installation limits before treating any related code as a replacement.
Application decision
Review the duty before choosing 1SAE351111R0140 ESB63-40N-01. Use the device for commanded building or industrial loads only after checking the actual load type, inrush, continuous current and switching frequency. Four switched conductors require careful neutral and phase identification.
The decision for 1SAE351111R0140 ESB63-40N-01 should record actual load or process limits, operating environment, normal behavior and the response to a fault. This avoids a selection based only on a familiar series name.
Order and compatibility gate
When specifying 1SAE351111R0140 ESB63-40N-01, Check coil source, contact arrangement, modular width and any auxiliary or manual-control accessory. The -06 coil variant uses a different control voltage and must not be substituted on appearance alone.
Send the full designation 1SAE351111R0140 ESB63-40N-01, hardware or serial revision, quantity, delivery need and nameplate photograph with the RFQ. Require written confirmation of any proposed successor or option-code change.
Installation and proving
For 1SAE351111R0140 ESB63-40N-01, Isolate all switched poles and control supply. Confirm torque, wiring, contact feedback and the intended on/off sequence; test the load under normal operating conditions.
Record the as-left settings, test results and installed interfaces of 1SAE351111R0140 ESB63-40N-01. Make the asset record searchable by the complete designation, not only by a short family label.
Same-series designation index
The codes below share a product family or an identified order-code relationship with 1SAE351111R0140 ESB63-40N-01. They may differ in rating, software, connections, options or approvals; none is automatically interchangeable.
- ESB63-40N-01
- ESB63-40N-01 1SAE351111R0140
- ESB63-63/24 GHE3491102R0001
Handover record
The buyer and site engineer should agree on a single verified configuration for 1SAE351111R0140 ESB63-40N-01, including accessories, documentation and the accepted test procedure. Keep deviations visible to both procurement and maintenance.
Retain 1SAE351111R0140 ESB63-40N-01 in the purchase order, asset register and commissioning record. ABB family specifications help identify the device, but the approved project documents determine whether it is suitable for this installation.
