Engineering boundaries for ABB 2TLA019995R0200

ABB 2TLA019995R0200 represents JSHD4 three-position enabling devices for a defined industrial task. An enabling switch needs an approved operating mode and full safety circuit. The notes below separate confirmed family data from project-specific information that must be verified before an order or replacement is approved.

Technical identity and selection limits

The technical table for ABB 2TLA019995R0200 applies to the representative reference. Similar codes can differ in electrical rating, mechanism, approvals, terminal layout or installed accessories.

Application boundary

The intended duty for ABB 2TLA019995R0200 is to enable controlled movement only while the operator uses the intended grip. Define the actual process, panel or machine condition first. Verify whether the device is the active control element, a measurement interface, a protection component or a passive spare. That distinction controls the rest of the selection.

For ABB 2TLA019995R0200, describe the system requirement in terms of inputs, outputs, connected loads and environmental limits. The presence of a familiar ABB family marking is useful for finding documentation but is not a substitute for the complete configuration.

Procurement evidence

A purchase request for ABB 2TLA019995R0200 should carry the complete order reference, equipment tag, quantity and any required revision. Compare button arrangement, cable pinout and safety-function design. Ask the supplier to state deviations and included accessories before approval.

A close substitute for ABB 2TLA019995R0200 needs a documented fit and function assessment. Keep separate the purchase of a complete device, a repair board, an installation accessory and a spare kit; each has different acceptance evidence.

Electrical or process interface

Map the ABB 2TLA019995R0200 terminals or process connections against the current drawing. Check supply limits, polarity, load category, signal range, protective earth, hazardous-area constraints or controller compatibility as applicable to this specific series.

The ABB 2TLA019995R0200 interface review should include cable length, shielding, mounting clearance and service access. If software or firmware participates in the function, record the approved version and configuration backup.

Failure modes to exclude

Before installing ABB 2TLA019995R0200, identify plausible wrong-part scenarios: altered suffix, incorrect voltage, different contact arrangement, incompatible process material or an omitted safety accessory. Any such difference should stop an automatic replacement decision.

For ABB 2TLA019995R0200, a visual match does not prove the same trip behavior, measurement accuracy or communication map. Use product marking and ABB documentation to resolve ambiguous entries rather than silently assigning a specification.

Receiving and traceability

Compare the delivered ABB 2TLA019995R0200 label with the approved quotation and original equipment record. Inspect packaging, connector condition, terminals, mechanical features and documentation. Isolate damaged or mismatched stock pending engineering review.

Record the ABB 2TLA019995R0200 serial or batch information where available. Website category imagery is illustrative and must not be treated as proof of a particular shipped configuration.

Installation sequence

Qualified personnel should install ABB 2TLA019995R0200 under the plant's isolation and permit process. Confirm fit and wiring before energization. Configure only approved settings, and document any parameter changed from the baseline.

After ABB 2TLA019995R0200 is fitted, prove release and over-squeeze stop behavior. A healthy power indicator alone does not prove the complete connected function or safe-state response.

Acceptance record

The acceptance record for ABB 2TLA019995R0200 should identify the test conditions, measured result, person responsible and any remaining restriction. Include upstream and downstream interfaces, not just the component itself.

Retain the final ABB 2TLA019995R0200 wiring or loop drawing, settings and verified order code. These records will make a future maintenance comparison faster and safer.

Approval point

Release ABB 2TLA019995R0200 for purchase or use only when its full identity, duty, installation interface and acceptance test agree.

Keep the approved ABB 2TLA019995R0200 evidence with the equipment record so a later replacement can be assessed against a known baseline.