ABB 2CDG110190R0011 technical selection record
ABB 2CDG110190R0011 is the representative reference for the AE/S 4.1.1.3 series. Its decision starts with the intended duty: bring analog field values onto a KNX bus. The technical values below identify this representative, not every series variant.
Technical reference for the representative
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 2CDG110190R0011 |
| Product family | AE/S 4.1.1.3 |
| Component role | four-channel KNX analog input |
| Exact ABB order reference | 2CDG110190R0011 |
| ABB product series | AE/S 4.1.1.3 |
| ABB type | AE/S 4.1.1.3 |
| Channels | Four analog inputs |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Use the delivered ABB 2CDG110190R0011 marking and current manufacturer documentation to confirm all limits and options before engineering approval.
Decision 1 — identify the actual function
For ABB 2CDG110190R0011, document the existing device's job, connected circuit and expected behavior. The four-channel KNX analog input description helps browsing, but does not prove interchangeability.
Check whether ABB 2CDG110190R0011 is a direct maintenance replacement or part of a revised design. Treat any changed function as an engineering decision.
Decision 3 — document procurement boundaries
Quote ABB 2CDG110190R0011 with its complete designation and the approved series, function and application. Ask suppliers to identify every proposed change to current rating, options, firmware or accessories.
Keep ABB 2CDG110190R0011 separate from apparently similar products in another ABB series. Cross-series pairing requires explicit manufacturer compatibility evidence.
Decision 5 — commission and retain evidence
Install ABB 2CDG110190R0011 only under the approved isolation and commissioning procedure, then compare measured values with engineering units. Record observed results against the design intent.
Store the ABB 2CDG110190R0011 test record with the asset tag, drawing revision and order history so a later technician can verify the exact configuration.
Decision 2 — compare electrical and mechanical interfaces
Before specifying ABB 2CDG110190R0011, verify sensor signal range, input mapping and supply. Compare drawings and the real installation, including terminals, clearances, mounting and the relevant supply.
The ABB AE/S 4.1.1.3 family contains order references with possible differences. For ABB 2CDG110190R0011, a matching series name is insufficient without a full rating and connection check.
Decision 6 — plan a future replacement
A later replacement of ABB 2CDG110190R0011 must be checked again for series, interfaces, ratings and approvals. The related references below are useful for enquiry, not automatic substitutes.
If ABB 2CDG110190R0011 is unavailable, request a written comparison and repeat acceptance testing for any proposed alternate code.
Decision 4 — receive and inspect
When ABB 2CDG110190R0011 arrives, compare the nameplate and order code with the purchase record. Check housing, connectors and supplied accessories for damage or omissions.
Place ABB 2CDG110190R0011 on hold if the delivered marking differs from the accepted specification. Resolve the difference before installation.
Release criterion
Approve ABB 2CDG110190R0011 after the identity, duty, interface and site test all agree with the approved specification.
Keep ABB 2CDG110190R0011 and its exact order reference on the final equipment record; series grouping is for navigation and selection review.
