ABB 1SFA619100R1022 technical procurement brief

ABB 1SFA619100R1022 is used to give a two-contact local command. The checks below help identify the exact article and verify its operating position.

Verified technical data

The ABB 1SFA619100R1022 figures shown above are tied to the cited ABB reference. Confirm configuration-dependent details on the delivered marking and project documentation.

Engineering evidence to collect

For ABB 1SFA619100R1022, retain the as-built drawing, host-equipment identity and an image of the removed part. Check the device position against the circuit and the maintenance record.

The ABB 1SFA619100R1022 code can have adjacent options within its family. State the required electrical and mechanical interfaces explicitly in the request for quotation, even when the old unit is available for comparison.

Procurement decision

Specify ABB 1SFA619100R1022 by its complete order code, not by an informal family label or appearance. This article is for green compact flush momentary pushbutton with 2NO; the buyer should request the exact marking and an applicable manufacturer data sheet.

Before accepting ABB 1SFA619100R1022, confirm contact count, color and circuit duty. A supplier's proposed substitute needs a documented difference review covering fit, ratings, approvals and duty.

Incoming inspection

On delivery, compare the package and device label with ABB 1SFA619100R1022. Inspect terminals, actuator or housing, accessories and visible damage before taking the equipment out of service.

If the supplied unit differs from ABB 1SFA619100R1022 in voltage, current range, color, contact arrangement, software entitlement or connection, quarantine it for technical review rather than relying on a similar catalog photograph.

Functional acceptance

After installation of ABB 1SFA619100R1022, prove both NO paths and button return. Write down test conditions, expected response and actual response in the handover record.

For ABB 1SFA619100R1022, include both normal operation and the off-state or alarm condition where applicable. Where a safety function is involved, verify the assembled system rather than only the individual component.

Installation constraints

Plan isolation and stored-energy control before work on ABB 1SFA619100R1022. Only trained personnel should connect or configure the device in accordance with the host equipment instructions.

Map each ABB 1SFA619100R1022 lead, terminal, mounting point or software dependency. Verify clearances and separately ordered components, and preserve the original part until the replacement passes acceptance.

Spare-parts decision

Determine whether ABB 1SFA619100R1022 must be held as a site spare or ordered against a planned shutdown. Consider lead time, repair criticality and storage conditions without assuming a nearby code is equivalent.

If ABB 1SFA619100R1022 is discontinued, ask ABB or a qualified supplier for a documented successor and compare mounting, wiring and performance before a change is approved.

Maintenance handover

Archive the ABB 1SFA619100R1022 order code, manufacturer document, as-left setting and dated installation photo with the asset. These records reduce ambiguity at the next service event.

Treat ABB 1SFA619100R1022 as an exact article for purchasing. Related codes below are enquiry references within the same series, not automatic substitutes; each variant has to be checked against its own parameters.

Other same-series order codes

The following codes appear with ABB 1SFA619100R1022 in the same product series. Different current ranges, colors, contacts, ratings or accessories can make them non-interchangeable. A code listed here is covered on this page and is not planned as a separate product page.

• 1SFA619100R1072
• 1SFA619100R1076

Order-release checklist

Release an ABB 1SFA619100R1022 order only after its complete code, duty and connection have been cross-checked with the equipment record.

After work on ABB 1SFA619100R1022, retain the acceptance evidence with the asset and update the spare record.