Identifying and maintaining ABB 1SCA022380R8770
This field-service note identifies ABB 1SCA022380R8770 and the checks that separate its exact configuration from visually similar equipment.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SCA022380R8770 |
| Product family | OHB45J6 |
| Component role | black 45 mm pistol-grip switch handle |
| Exact ABB order code | 1SCA022380R8770 |
| Product series | OHB45J6 |
| Handle length | 45 mm |
| Shaft | 6 mm profile |
| Colour | Black |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
For ABB 1SCA022380R8770, confirm version-specific limits against its marking and the cited ABB publication before applying the table to an installation.
Nameplate and order-code checkpoint
Start the service record with ABB 1SCA022380R8770, including every character of its ordering code. Confirm the delivered marking and the installed equipment drawing agree before changing wiring or ordering a spare.
The family image for ABB 1SCA022380R8770 is a reference image; it cannot establish the exact contact layout, coil, actuator or approved accessory combination.
Normal-duty path
In the intended assembly, ABB 1SCA022380R8770 is used to operate a compatible disconnect switch. Trace the energy or signal path from supply through the device and onward to the controlled equipment.
For ABB 1SCA022380R8770, verify shaft profile, panel depth and lockout. Treat a similar catalog number as a different configuration until the full ABB designation has been compared.
Failure symptoms and first checks
If ABB 1SCA022380R8770 fails to switch or signal correctly, isolate the system under the approved procedure and compare the observed state with the electrical drawing. Check supply, wiring, host fit and mechanical travel before replacing parts.
Record any ABB 1SCA022380R8770 abnormal heating, loose termination, damaged enclosure or inconsistent contact timing. Do not infer a root cause from the part photograph alone.
Installation and restoration
Qualified personnel should fit ABB 1SCA022380R8770 only within the applicable electrical ratings, isolation rules and manufacturer instructions. Verify terminal treatment, mounting clearance and the companion component specified for the installation.
After work on ABB 1SCA022380R8770, test full ON/OFF travel. Capture the tested state and the as-left code in the maintenance record.
Spare and substitution decision
A substitute for ABB 1SCA022380R8770 needs a documented match in electrical duty, geometry, terminal style and any safety or environmental approvals. Similar-looking variants are not automatically interchangeable.
Keep ABB 1SCA022380R8770 as the purchase reference until engineering confirms a different code. The full source link below can be used to review the manufacturer's family information.
Handover record
For ABB 1SCA022380R8770, retain the exact code, service date, measured or observed contact state and any companion equipment identification. This helps the next technician repeat the acceptance check.
Before closing a work order for ABB 1SCA022380R8770, compare the installed condition with the approved operating and fault-response sequence.
Manufacturer reference and sign-off
ABB 1SCA022380R8770 should be accepted only after the device identity, application duty and installation test are documented.
Use the ABB 1SCA022380R8770 manufacturer reference to resolve any option or revision that this general service note does not decode.
