ABB 1SBV015914R3801 field-service specification
This field-service note identifies ABB 1SBV015914R3801 and the checks that separate its exact configuration from visually similar equipment.
Key technical data
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SBV015914R3801 |
| Product family | LS20P14B11-U01 |
| Component role | compact prewired roller-plunger limit switch |
| Exact ABB order code | 1SBV015914R3801 |
| Product series | LS20P14B11-U01 |
| Contacts | 1 NO + 1 NC snap action |
| Actuator | Cross roller plunger |
| Enclosure | IP67 family listing; verify fitted cable |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
For ABB 1SBV015914R3801, confirm version-specific limits against its marking and the cited ABB publication before applying the table to an installation.
Nameplate and order-code checkpoint
Start the service record with ABB 1SBV015914R3801, including every character of its ordering code. Confirm the delivered marking and the installed equipment drawing agree before changing wiring or ordering a spare.
The family image for ABB 1SBV015914R3801 is a reference image; it cannot establish the exact contact layout, coil, actuator or approved accessory combination.
Installation and restoration
Qualified personnel should fit ABB 1SBV015914R3801 only within the applicable electrical ratings, isolation rules and manufacturer instructions. Verify terminal treatment, mounting clearance and the companion component specified for the installation.
After work on ABB 1SBV015914R3801, prove repeatable make/break points. Capture the tested state and the as-left code in the maintenance record.
Failure symptoms and first checks
If ABB 1SBV015914R3801 fails to switch or signal correctly, isolate the system under the approved procedure and compare the observed state with the electrical drawing. Check supply, wiring, host fit and mechanical travel before replacing parts.
Record any ABB 1SBV015914R3801 abnormal heating, loose termination, damaged enclosure or inconsistent contact timing. Do not infer a root cause from the part photograph alone.
Normal-duty path
In the intended assembly, ABB 1SBV015914R3801 is used to detect position in a compact machine. Trace the energy or signal path from supply through the device and onward to the controlled equipment.
For ABB 1SBV015914R3801, verify roller approach, prewired cable and ingress protection. Treat a similar catalog number as a different configuration until the full ABB designation has been compared.
Spare and substitution decision
A substitute for ABB 1SBV015914R3801 needs a documented match in electrical duty, geometry, terminal style and any safety or environmental approvals. Similar-looking variants are not automatically interchangeable.
Keep ABB 1SBV015914R3801 as the purchase reference until engineering confirms a different code. The full source link below can be used to review the manufacturer's family information.
Handover record
For ABB 1SBV015914R3801, retain the exact code, service date, measured or observed contact state and any companion equipment identification. This helps the next technician repeat the acceptance check.
Before closing a work order for ABB 1SBV015914R3801, compare the installed condition with the approved operating and fault-response sequence.
Manufacturer reference and sign-off
ABB 1SBV015914R3801 should be accepted only after the device identity, application duty and installation test are documented.
Use the ABB 1SBV015914R3801 manufacturer reference to resolve any option or revision that this general service note does not decode.
