ABB 1SBN010110R1001 assembly interface
This bill-of-materials guide sets out how ABB 1SBN010110R1001 fits with its host equipment and the checks needed for a safe purchase decision.
Technical parameters
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SBN010110R1001 |
| Product family | CA4-01 |
| Component role | single-pole front auxiliary contact block |
| Exact ABB order code | 1SBN010110R1001 |
| Product series | CA4-01 |
| Representative contact | 1 NC |
| Mounting | Front |
| Host | AF09–AF96 and NF/NFZ; verify exact version |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
Use the ABB 1SBN010110R1001 values with the cited ABB source and the delivered item marking; the table does not replace application-specific design verification.
Component identity in the bill of materials
Use ABB 1SBN010110R1001 as the exact purchase line, not a shortened series name. Confirm the installed marking, approved drawing and ABB record agree before issuing an order.
ABB 1SBN010110R1001 identifies single-pole front auxiliary contact block. Photos can illustrate the family, but may not show the exact supplied coil, contact insert, length or accessory revision.
Installation handoff to the technician
Qualified personnel should isolate the system before fitting ABB 1SBN010110R1001. Confirm wiring, fastening and protective arrangements and keep the as-left configuration recorded.
After installation of ABB 1SBN010110R1001, prove auxiliary state. Include normal and relevant fault or off states in the approved test procedure.
Electrical and mechanical interface
Document what ABB 1SBN010110R1001 mates with: power conductors, a control supply, an auxiliary block, a switch handle or a host contactor as applicable. The assembly boundary matters more than a similar-looking front face.
Check ABB 1SBN010110R1001 terminal layout, mounting envelope, clearances and companion parts against the installed panel and latest manufacturer instructions.
Selection decision for the application
The intended ABB 1SBN010110R1001 role is to add an auxiliary state signal. Compare duty, host fit and ratings before accepting the configuration.
For ABB 1SBN010110R1001, specifically verify host compatibility and NO/NC need. Where a value is option-dependent, inspect the delivered marking and ABB documentation instead of applying another variant's data.
Substitution and spare-part control
A related code can differ from ABB 1SBN010110R1001 in coil, contact layout, shaft length, host frame or approvals. A shared family name is not a guarantee of interchangeability.
If ABB 1SBN010110R1001 is replaced, obtain a documented comparison and engineering acceptance, then update the spare list and equipment drawings.
Procurement close-out
Preserve the ABB 1SBN010110R1001 exact order code, manufacturer URL, chosen companions, test result and dated installed photograph with the asset record.
This record makes later ABB 1SBN010110R1001 sourcing and service decisions traceable without relying on memory or an unverified visual match.
Related codes retained on this page
The following ABB codes are grouped under ABB 1SBN010110R1001 and will not be given separate product pages. Their exact electrical or mechanical options must still be checked individually.
- 1SBN010110R1010
Final acceptance note
Approve ABB 1SBN010110R1001 only after exact identity, host interface and technical limits are documented.
Keep the ABB 1SBN010110R1001 acceptance result with the as-left bill of materials and manufacturer reference.
