Identifying ABB 1SBL371001R8000 for a controlled replacement
This configuration guide supports accurate identification and application review of ABB 1SBL371001R8000.
Technical parameters at a glance
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SBL371001R8000 |
| Product family | A63-30-00 |
| Component role | three-pole A63 AC-operated contactor |
| Exact ABB order code | 1SBL371001R8000 |
| Product series | A63-30-00 |
| Main poles | 3 |
| Integrated auxiliary | None in -00 arrangement |
| Coil | 220–230 V 50 Hz / 230–240 V 60 Hz for R8000 |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
The table describes ABB 1SBL371001R8000 using the cited ABB material. Confirm any option-specific limit on the delivered device and current documentation.
Decode the complete designation
ABB 1SBL371001R8000 identifies three-pole A63 AC-operated contactor. The complete order code is the procurement anchor; the series alone does not identify coil, contact pattern or accessory fit.
For ABB 1SBL371001R8000, reconcile the installed label, engineering drawing and manufacturer record before ordering.
Trace the control supply
Follow the supply path to ABB 1SBL371001R8000, checking the actual voltage, AC frequency or DC polarity as applicable. A sibling coil version may not operate safely on the same circuit.
Do not energize ABB 1SBL371001R8000 until the coil code and panel supply have been compared against the delivered unit.
Check the switched circuit
The assigned duty is to control a higher-current motor feeder. Validate the utilization category, contact arrangement, load current and terminal conductors for ABB 1SBL371001R8000 within the complete assembly.
Confirm ABB 1SBL371001R8000 is paired with a suitable protective device and, where needed, an appropriately selected overload relay.
Map signals and accessories
For ABB 1SBL371001R8000, document every main and auxiliary terminal in the scheme. Verify front or side accessory compatibility instead of relying on a photograph of a similar frame.
A replacement ABB 1SBL371001R8000 must leave the intended interlock, alarm and feedback logic intact; accessories should be separately specified.
Installation and functional proof
Qualified personnel should isolate the supply and inspect ABB 1SBL371001R8000 mechanical fit, torque requirements and wiring against current manufacturer instructions. Prove all poles and dropout.
Record ABB 1SBL371001R8000 pickup, dropout, contact response and protective-system behavior before returning the circuit to service.
Replacement decision record
If another code is proposed for ABB 1SBL371001R8000, compare coil, contacts, frame, approvals, duty and mounting item by item. Similar family numbers alone do not establish interchangeability.
Keep the ABB 1SBL371001R8000 exact code, source document, test result and as-left photograph in the asset file for later maintenance.
Other order codes within this series
The following codes are grouped on the ABB 1SBL371001R8000 page and will not be published as individual product pages. Compare every complete code: coil or other options can differ even within one series.
- 1SBL371001R8400
Configuration close-out
Approve ABB 1SBL371001R8000 only when the full designation, electrical interface, load and companion parts match the intended design.
For ABB 1SBL371001R8000, retain commissioning evidence and the latest ABB technical reference with the maintenance record.
