ABB 1SBH137001R1131 configuration and installation path
This configuration guide supports accurate identification and application review of ABB 1SBH137001R1131.
Technical parameters at a glance
| Technical item | Verified value / selection note |
|---|---|
| Complete designation | 1SBH137001R1131 |
| Product family | NF31E-11 |
| Component role | 3NO+1NC auxiliary contactor relay |
| Exact ABB order code | 1SBH137001R1131 |
| Product series | NF31E-11 |
| Contact arrangement | 3 NO + 1 NC |
| Control voltage | 24–60 V AC / 20–60 V DC for -11 |
| Family | NF electronic-coil relay |
| Final configuration | Confirm exact nameplate, hardware revision and order options before purchase |
The table describes ABB 1SBH137001R1131 using the cited ABB material. Confirm any option-specific limit on the delivered device and current documentation.
Check the switched circuit
The assigned duty is to implement mixed NO/NC control logic. Validate the utilization category, contact arrangement, load current and terminal conductors for ABB 1SBH137001R1131 within the complete assembly.
Confirm ABB 1SBH137001R1131 is paired with a suitable protective device and, where needed, an appropriately selected overload relay.
Decode the complete designation
ABB 1SBH137001R1131 identifies 3NO+1NC auxiliary contactor relay. The complete order code is the procurement anchor; the series alone does not identify coil, contact pattern or accessory fit.
For ABB 1SBH137001R1131, reconcile the installed label, engineering drawing and manufacturer record before ordering.
Map signals and accessories
For ABB 1SBH137001R1131, document every main and auxiliary terminal in the scheme. Verify front or side accessory compatibility instead of relying on a photograph of a similar frame.
A replacement ABB 1SBH137001R1131 must leave the intended interlock, alarm and feedback logic intact; accessories should be separately specified.
Trace the control supply
Follow the supply path to ABB 1SBH137001R1131, checking the actual voltage, AC frequency or DC polarity as applicable. A sibling coil version may not operate safely on the same circuit.
Do not energize ABB 1SBH137001R1131 until the coil code and panel supply have been compared against the delivered unit.
Installation and functional proof
Qualified personnel should isolate the supply and inspect ABB 1SBH137001R1131 mechanical fit, torque requirements and wiring against current manufacturer instructions. Prove all no/nc transitions.
Record ABB 1SBH137001R1131 pickup, dropout, contact response and protective-system behavior before returning the circuit to service.
Replacement decision record
If another code is proposed for ABB 1SBH137001R1131, compare coil, contacts, frame, approvals, duty and mounting item by item. Similar family numbers alone do not establish interchangeability.
Keep the ABB 1SBH137001R1131 exact code, source document, test result and as-left photograph in the asset file for later maintenance.
Other order codes within this series
The following codes are grouped on the ABB 1SBH137001R1131 page and will not be published as individual product pages. Compare every complete code: coil or other options can differ even within one series.
- 1SBH137001R1331
Configuration close-out
Approve ABB 1SBH137001R1131 only when the full designation, electrical interface, load and companion parts match the intended design.
For ABB 1SBH137001R1131, retain commissioning evidence and the latest ABB technical reference with the maintenance record.
