Power-supply replacement planning for 7000815-0000
7000815-0000 is a Dell power-related identifier, but compatibility depends on the installed platform, connector, input range and PSU bay. Verify the physical label and chassis service tag before treating a wattage or cross-reference match as sufficient.
Identification and electrical table
| Selection point | Specification / confirmation |
|---|---|
| Exact model | 7000815-0000 |
| Part number | 7000815-0000; cross-reference D3014 is reported in parts listings |
| Rated output | 930 W as reported by parts listings; verify label |
| Electrical input | 100–240 V AC, 50/60 Hz as reported; inspect unit label |
| Platform | Legacy PowerEdge compatibility must be checked by service tag |
| Safety | Use only approved system-specific replacement parts |
| Exact code | 7000815-0000 |
Before ordering 7000815-0000
Capture the complete part number, revision, output rating and input data from the existing unit. Check whether 7000815-0000 is hot-swap or cabled, whether the chassis requires a matched redundant pair, and whether firmware reports the replacement as supported. Do not mix a visually similar supply without checking the platform documentation.
- Record server model and service tag.
- Compare voltage, wattage, connector and physical dimensions.
- Confirm redundancy mode and load requirements.
- After replacement, check PSU health, alerts and redundancy status.
Maintenance record for 7000815-0000
Include 7000815-0000, the complete label, server service tag, PSU bay and replacement result in the asset log. Keep the approved part cross-reference with the quote to prevent a mismatched power component on a later service call.
Confirm 7000815-0000 against the exact server label before approving a replacement supply.
